Pcie Riser Board; Dimms - HP ProLiant DL360p Gen8 Maintenance And Service Manual

PCIe riser board

To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel
4.
Remove the PCI riser cage
5.
Remove any installed expansion boards
6.
Remove the PCIe riser board.
7.
The x16 PCIe riser board (shown) has 2 screws to remove from the assembly; the x8 PCIe riser board
(on the other side of the PCI riser cage) has 3 screws to remove from the assembly.
To replace the component, reverse the removal procedure.

DIMMs

To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel
4.
If installed, remove the FBWC capacitor pack
5.
("Access panel" on page 29).
("PCI riser cage" on page 42).
("Expansion
("Access panel" on page 29).
("FBWC capacitor
boards" on page 43).
pack" on page 37).
Removal and replacement procedures 44