Dvd-Rom Or Dvd-Rw Drive - HP ProLiant DL360p Gen8 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

DVD-ROM or DVD-RW drive

To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel
4.
If installed, remove the FBWC capacitor pack
5.
For SFF, do the following:
6.
Disconnect the SATA DVD cable from the system board to fully remove the DVD drive from the bay
a.
("DVD-ROM and DVD-RW drive
Remove the DVD drive from the server.
b.
Disconnect the SATA DVD cable from the rear of the DVD drive.
c.
For LFF, do the following:
7.
Remove the DVD drive from the server.
a.
You may need to disconnect the SATA DVD cable from the system board to fully remove the DVD
drive from the drive bay.
("Access panel" on page 29).
("FBWC capacitor
cabling" on page 61).
pack" on page 37).
Removal and replacement procedures 33