Fan Blank - HP ProLiant DL360p Gen8 Maintenance And Service Manual

The illustration shows fans 1 and 2 removed for a single-processor configuration.
To replace the component:
Install the fan module.
1.
Install the access panel
2.
Slide the server into the rack.
3.
Power up the server.
4.

Fan blank

Install fans 1 and 2 only when processor 2 is installed. When only one processor is installed, install the fan
blanks in bays 1 and 2
To remove the component:
Power down the server (on page 25).
1.
("Access panel" on page 29).
("Fan modules" on page 76).
Removal and replacement procedures 35