HP ProLiant DL360p Gen8 Maintenance And Service Manual page 56

Close the processor retaining bracket. When the processor is installed properly inside the processor
4.
retaining bracket, the processor retaining bracket clears the flange on the front of the socket.
CAUTION: Do not press down on the processor. Pressing down on the processor may cause
damage to the processor socket and the system board. Press only in the area indicated on the
processor retaining bracket.
Press and hold the processor retaining bracket in place, and then close each processor locking lever.
5.
Press only in the area indicated on the processor retaining bracket.
Install the processor socket cover onto the processor socket of the failed system board.
6.
Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
7.
Allow the alcohol to evaporate before continuing.
Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
8.
Removal and replacement procedures 56