System Battery - HP ProLiant DL360p Gen8 Maintenance And Service Manual

Connect each power cord to the power source.
9.
Power up the server.
10.

System battery

If the server no longer automatically displays the correct date and time, you may need to replace the battery
that provides power to the real-time clock. Under normal use, battery life is 5 to 10 years.
WARNING:
pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack is not
properly handled. To reduce the risk of personal injury:
Do not attempt to recharge the battery.
•
Do not expose the battery to temperatures higher than 60°C (140°F).
•
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Replace only with the spare designated for this product.
•
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend or remove the server from the rack
3.
server from the
Remove the access panel
4.
If installed, remove the FBWC capacitor pack
5.
Locate the battery on the system board
6.
Remove the battery.
7.
IMPORTANT:
configuration. After replacing the battery, reconfigure the system through RBSU.
The computer contains an internal lithium manganese dioxide, a vanadium
rack" on page 26).
("Access panel" on page 29).
("System board
Replacing the system board battery resets the system ROM to its default
("Extend the server from the
("FBWC capacitor pack" on page 37).
components" on page 70).
Removal and replacement procedures 52
rack" on page 26, "Remove the