Pci Riser Cage - HP ProLiant DL360p Gen8 Maintenance And Service Manual

Remove the air baffle.
6.
To replace the component, reverse the removal procedure.

PCI riser cage

To remove the component:
CAUTION:
remove all AC power cords before removing or installing the PCI riser cage.
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel
4.
Remove the PCI riser cage:
5.
Disconnect external cables connected to any existing expansion boards.
a.
Disengage the two PCI riser cage thumbscrews. Lift the tab, rotate 180 degrees, and the
b.
thumbscrew pops up.
To prevent damage to the server or expansion boards, power down the server and
("Access panel" on page 29).
Removal and replacement procedures 42