Prepare the hard drive.
2.
Install the hard drive.
3.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations
4.
SATA hard drive LED
DVD-ROM and DVD-RW drive option
This server supports the installation of a DVD-ROM drive or a DVD-RW drive. When an optical drive is
installed, the server does not support the additional hard drive backplane.
To install the component:
Power down the server (on page 20).
1.
Extend the server from the rack (on page 20).
2.
Remove the access panel (on page 22).
3.
Remove the dual hard drive bezel blank
4.
combinations" on page 17).
("Removing the dual hard drive bezel
("SAS and
blank" on page 48).
Hardware options installation 49