Descriptions Of Various Simulations - Sharp AL-2051 Service Manual

Sim Sub
No. code
50 01 Lead edge image position
06 Copy lead edge position adjustment (RSPF)
10 Center offset adjustment
12 Document off-center adjustment
18 Memory reverse position adjustment in duplex
copy
19 Duplex copy rear edge void adjustment
51 02 Resist quantity adjustment
53 08 RSPF scan position automatic adjustment
61 03 Polygon motor check (HSYNC output check)
63 01 Shading check
02 Black level automatic correction
12 Light quantity stabilization wait time setting
13 Light quantity stabilization band setting
64 01 Self print

4. Descriptions of various simulations

Main Sub
Contents
code code
1 01 Mirror scan operation
02 Mirror home position sensor
(MHPS) status display
06 Aging of mirror scanning
2 01 RSPF aging operation
Operation
[Function]
When [ENTER]/[START] key is pressed, the home position is checked and the mirror base per-
forms full scan at the speed of the set magnification ratio.
During operation, the set magnification ratio is displayed.
The mirror home position sensor status is displayed with the "Copy mode lamp".
(When the mirror is in the home position, the lamp lights up.)
During operation, the copy lamp lights up.
When [Clear] key is pressed, if the operation is on the way, it is terminated and the machine
goes to the sub code entry standby mode.
[Operation]
1) Initial display
01-01 SCAN CHK
- 100% +
[Function]
Monitors the mirror home position sensor, and makes the "Copy mode lamp". Turn on during
the sensor ON status.
[Operation]
1) Initial display
01-02 MHP-SENSOR
EXECUTING...
[Function]
When [ENTER]/[START] key is pressed, the mirror base performs full scan at the speed of the
set magnification ratio.
During operation, the set magnification ratio is displayed.
After 3sec, the mirror base performs full scan again.
[Operation]
The operation is similar to simulation 1-01.
[Function]
When [ENTER]/[START] key is pressed, the set magnification ratio is obtained. For the SPF, the
single-face document transport is performed. For the RSPF, the duplex document transport is
performed.
However, the operating conditions don't matter and the operation is not stopped even in case of
a jam. Also the magnification ratio is displayed on the LCD/display.
[Operation]
The operation is similar to simulation 1-01.
AL-2051 SIMULATION, TROUBLE CODES 10 - 2
Details of function/operation
2) [ZOOM] key
01-01 SCAN CHK
- 78% +
2) [ ] key
01-01 SCAN CHK
- 99% +
2) [ ] key
01-01 SCAN CHK
- 101% +
3) [ENTER]/[START] key
01-01 SCAN CHK
EXECUTING... - 78% +