Set (Menu) Mode - Yaesu VX-6E Operating Manual

The VX-6E Set Mode, already described in parts of many previous chapters, is easy to
activate and set. It may be used for configuration of a wide variety of transceiver param-
eters, some of which have not been detailed previously. Use the following procedure to
activate the Set Mode:
1. Press the [ F/W ] key, then press the [ 0 ( SET )] key to enter the Set mode.
2. Rotate the DIAL knob to select the Set Mode Item to be ad-
justed.
3. Press the [ 0 ( SET )] key momentarily to enable adjustment of
the Set Mode Item.
4. Rotate the DIAL knob to adjust or select the parameter to be
changed on the Set Mode Item selected in above step.
5. After completing your selection and adjustment, press the PTT switch momentarily
to save the new setting and exit to normal operation.
Some Set Mode Items (like Set Mode Item 50: TN FRQ) require that the
[ 0(SET) ] key be pressed after setting of the parameter, and before exiting to
normal operation.
"MY MENU" Short-cut Key Setup
In the factory default, the primary (press key) function of the [
activating the Internet Connection feature. However, you may change the primary (press
key) function of the [
Items.
1. Press and hold in the [
switches the [
"MY MENU" key function.
2. Recall the Set Mode Item which you wish to assign to the [
Menu short-cut.
3. Press and hold in the [
to the [ ( LK ) TXPO ] key. "
command was executed.
4. Now, a momentary press of the [
lected Menu item. You must press the [
operation.
VX-6E O
PERATING
( LK ) TXPO ] key to a short-cut path for recall of one of Set Mode
( LK ) TXPO ] key while turning the radio on. This procedure
( LK ) TXPO ] key between the "Internet Connection" function and the
( LK ) TXPO ] key for one second to assign the Set Mode Item
MY KEY MY KEY MY KEY
MY KEY MY KEY
M
ANUAL
S
ET
" will appear on the display, to confirm that the
( LK ) TXPO ] key will immediately recall the se-
( LK ) TXPO ] key again to exit to normal
( M ) M
ENU ODE
( LK ) TXPO ] key is set to
( LK ) TXPO ] key as a
87