Yaesu VX-6E Operating Manual page 97

Set Mode Item 25 [ EDG.BEP ]
Function: Enables/Disables the Band-edge Beeper while selecting the frequency via the
DIAL knob.
Available Values: OFF/ON
Default: OFF
Set Mode Item 26 [ EMG S ]
Function: Selects the alarm(s) utilized when the Emergency function is engaged.
Available Values: BP+STR/BEAM/BP+BEM/CW/BP+CW/BEEP/STROBE
Default: BP+STR
BP+STR: Loud "Alarm" sounds and the TX/BUSY indicator flashes.
BEAM: The TX/BUSY indicator glows continuously in white.
BP+BEM: Loud "Alarm" sounds and the TX/BUSY indicator glows continuously in white.
Transmits the Morse Code "SOS" (• • • – – – • • •) message on the air begin-
CW:
ning one minute after activation of the Emergency function.
BP+CW: Loud "Alarm" sounds and the Morse Code "SOS" (• • • – – – • • •) message is
transmitted on the air beginning one minute after activation of the Emergency
function.
BEEP: Loud "Alarm" sounds.
STROBE: The TX/BUSY indicator lamp flashes.
When the radio is set to the CW or BP+CW mode, the radio will be instructed to send "DE
(your callsign)" after the sending of the SOS message, if your callsign is entered via Set
Mode Item 14: CW ID
CW ID CW ID. CW ID
CW ID
Set Mode Item 27 [ HLF.DEV ]
Function: Reducing the Deviation level by 50 %.
Available Values: OFF/ON
Default: OFF
Set Mode Item 28 [ HM/RV ]
Function: Selects the Primary function of the [ HM/RV ( EMG ) R/H ] key.
Available Values: REV/HOME
Default: REV
Pressing the [ HM/RV ( EMG ) R/H ] key reverses the transmit and receive frequen-
REV:
cies during repeater operation.
HOME: Pressing the [ HM/RV ( EMG ) R/H ] key instantly recalls a favorite "Home" chan-
nel.
Set Mode Item 29 [ INT CD ]
Function: Selects the Access Number (DTMF digit) for WIRES
Available Values: DTMF 1 - DTMF F
Default: DTMF 1
VX-6E O
PERATING
M
ANUAL
( M
S
ET ENU
operation.
TM
) M
ODE
95