Direct Memory Recall Channel - Yaesu VX-6E Operating Manual

M M
EMORY
The Direct Memory Recall Channel (DMR) feature allows you to recall up to ten favorite
frequencies directly via the numeric ([ 0 ] through [ 9 ]) keys. DMR channels may be se-
lected from the VFO, an already-programmed memory, or a Home channel.
Storing the "Direct Memory Recall" Channels
1. Set up the transceiver frequency according to the desired configuration, including
parameters such as CTCSS/DCS data, Repeater Shift, Power Level etc.
2. Press and hold in the numeric ([ 0 ] through [ 9 ]) key, corresponding to the Direct Memory
Recall Channel into which you wish to store this configuration, for 2 seconds.
3. You still will be operating in the "normal" mode (Memory, VFO, or Home Channel),
so you may now select other frequency, and store them into additional Direct Memory
Recall Channels, by repeating the above process.
Recalling the "Direct Memory Recall" Channels
1. Press and hold in the [ P ( DMR )] key for 2 seconds to recall the
Direct Memory Recall Channel mode. The "
pear at the upper left corner of the display while operating on a

Direct Memory Recall Channel.

2. Press the numeric ([ 0 ] through [ 9 ]) key correspond-
ing to the Direct Memory Recall Channel you wish
to recall.
3. Once you have recalled a DMR channel, you may
rotate the DIAL knob to change frequencies, as
though you were operating on the VFO.
4. If you wish to over-write the data stored on a par-
ticular DMR channel after tuning off of the origi-
nal frequency, just press and hold in (for 2 seconds)
the numeric key which was pressed in step 2.
5. To exit the Direct Memory Recall Channel mode, press and hold in the [ P ( DMR )] key
for 2 seconds.
42
ODE ( R
EGULAR
D M
IRECT EMORY
M C
EMORY HANNELS
R C
ECALL HANNEL
" icon will ap-
D
EFAULT
[ 1 ]
[ 2 ]
[ 3 ]
[ 4 ]
[ 5 ]
[ 6 ]
[ 7 ]
[ 8 ]
[ 9 ]
[ 0 ]
VX-6E O
)
DMR C F
HANNEL REQUENCY
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
144.000 MHz
M
PERATING ANUAL