Position Discharge Chute; Service Engine; Service Engine Coolant; Service Hydraulic Oil - Exmark Lazer Z XP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

3.7 POSITION DISCHARGE CHUTE.

3.7.1

3.8 SERVICE ENGINE.

3.9 SERVICE ENGINE COOLANT

3.10 SERVICE HYDRAULIC OIL

b) If the ends of the levers hit against each other while in the drive position (levers
rotated in as far as possible), make adjustments by moving the levers outwards
to the neutral lock position and carefully bend them outward. Move them back to
the drive position and check for clearance, repeat if necessary.
Loosen two (2) 5/16" nyloc nuts attaching discharge chute. Lower the discharge
chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.
Refer to Engine Owner's Manual
Machine is shipped filled with engine coolant.
POTENTIAL HAZARD
♦ Engine coolant is hot and pressurized.
♦ Radiator and surrounding parts are hot.
WHAT CAN HAPPEN
♦ Spray or steam from hot, pressurized liquid in the
engine cooling system or touching a hot radiator may
cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before removing
the radiator cap or servicing any component of the
cooling system.
POTENTIAL HAZARD
♦ Engine coolant is toxic.
WHAT CAN HAPPEN
♦ Swallowing coolant can cause poisoning.
HOW TO AVOID THE HAZARD
♦ Do not swallow
♦ Keep out of reach of children and pets.
With machine on level surface and with cool engine, remove radiator cap (under
hood) and add a 50/50 mix of water and Dex-Cool© extended life coolant until liquid
level is as high as possible without overflowing. Reinstall radiator cap, making sure
that the cap is completely seated by pressing down firmly while turning until the cap
stops. Add 50/50 coolant mix to overflow bottle on the left side of the engine as
required to bring the level up to the indicator line on the bottle.
NOTE: Units should only be filled with Dex-Cool© extended life coolant, which can
be identified by its orange color.
The machine is shipped with hydraulic oil in the reservoir. Run the machine for
approximately 15 minutes to allow any extra air to purge out of the hydraulic
system. Check hydraulic reservoir and if necessary fill the reservoir to the
appropriate level with Mobil 1 15W-50 synthetic motor oil. Replace hydraulic
reservoir cap and tighten until snug. DO NOT overtighten.
www.mymowerparts.com
WARNING
CAUTION
- 16 -