Adjustments - Exmark Lazer Z XP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.28
5.1.29

5.2 ADJUSTMENTS

IMPORTANT: Disengage PTO, shut off engine and remove key before servicing,
cleaning or making any adjustments to the unit.
5.2.1
g) Hydro pump tensioner retaining bolt.
h) Fuel tank bulkhead fitting threads.
Adhesives such as "Loctite RC/609 or RC/680" or "Fel-Pro Pro-Lock Retaining I
or Retaining II" are used on the following:
a) Fuel tank studs, where studs are inserted into tank.
Mobil HTS grease (or a food-grade antisieze) is used in the following locations:
a) Between the jackshaft and bearings
b) Between the jackshaft and sheaves.
c) Between the cutter housing spindle and bearings.
d) Between the cutter housing spindle and sheaves.
e) Under top cutter housing bearing guard.
f) Between fan pump shafts and motor shafts next to seal.
Dielectric grease is used on all blade type electrical connections to prevent
corrosion and loss of contact.
Cutting Height Adjustment.
a) Stop machine and move drive levers out to neutral lock position.
b) Disengage PTO.
c) Raise the deck lever to the transport position (also the 5" (12.7 cm) cutting
height position). See Figure 7.
The deck can be raised by pulling the deck lever up and/or by pushing on
the deck lift assist lever.
NOTE: When changing cutting height positions, always come to a
complete stop and disengage the PTO.
CUTTING HEIGHT POSITION
d) Insert height adjustment pin into hole corresponding to desired cutting
height and install hairpin cotter. See decals on the sides of deck lift plate.
e) Move lever out of the transport (or 5" (12.7 cm) cutting height) position and
down onto height adjustment pin to mow at selected height.
f) To transport, move lever back up to transport (or 5" (12.7 cm) cutting
height) position.
Note: The foot operated deck lift assist lever can be used to momentarily
lift the deck to clear objects. Be sure the PTO is disengaged.
g) Adjust anti-scalp rollers for Normal Operating Conditions. Stop engine, wait
for all moving parts to stop, and remove key. Place rollers in one of the
positions shown in Figure 8. Rollers will maintain 3/4 in. (19 mm) clearance
to the ground to minimize gouging and roller wear or damage.
www.mymowerparts.com
FIGURE 7
- 35 -