Exmark Lazer Z XP Operator's Manual page 36

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.13
5.1.14
5.1.15
∗ See Section 5.1.15 c) for special lubrication instructions on the front caster pivots and
Section 5.1.16 for special lubrication instructions on the front casters wheel hubs.
b) Clean area around hydraulic reservoir cap and remove cap. Oil level should
be to the top of the baffle inside the tank. If not, add oil. Use only Mobil 1
15W-50 synthetic motor oil. Replace hydraulic reservoir cap and tighten
until snug. DO NOT overtighten.
NOTE: The baffle has two levels. The upper level represents the "HOT"
level and the lower level represents the "COLD" level. The oil level varies
with the temperature of the oil. The "HOT" level shows the level of oil when it
is a 225°F (107°C). The "COLD" level shows the level of the oil when it is at
75°F (24°C). Fill to the appropriate level depending upon the temperature of
the oil. For example: If the oil is about 150°F (65°C), fill to halfway between
the "HOT" and "COLD" levels. If the oil is at room temperature (about 75°F
(24°C)), fill only to the "COLD" level.
Check tire pressures:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Inflate all four tires to 13 psi (90 kPa).
NOTE: Do not add any type of tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling tires will void the warranty.
Check condition of belts:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat up. Lift the rubber flaps on front side of the engine to check pump
drive belt and alternator drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) Remove bumper and check under machine to inspect the two mule drive belts
and fan pump drive belt.
e) See Sections 5.2.3, through 5.2.6 for belt adjustments.
Lubricate grease fittings:
Service Interval: Refer to chart.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose gun
grease. Refer to the following chart for fitting locations and lubrication schedule.
FITTING
LOCATIONS
1. Front Caster wheel hubs
2. Front Caster Pivots
3. Height Adj. Shaft Bearings
4. Deck Drive Belt Idler Arm
5. Brake Brackets
6. Fan Pump Belt Idler Arm
7. Wheel Drive Pump Belt Idler Arm
8. Deck Rear Struts
9. Mule Drive Belt Idler Arms
www.mymowerparts.com
LUBRICATION CHART
INITIAL NO. of
PUMPS PLACES
∗0
∗0
1
1
1
1
1
1
1
- 31 -
SERVICE
INTERVAL
∗yearly
2
2 ∗yearly
5 40 hours
1 40 hours
2 200 hours
1 40 hours
1 40 hours
2 40 hours
2 40 hours