Adjustments - Exmark Lazer Z XP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.2.14
NOTE: The nuts to the front of the unit on RH rod has left-hand threads.
MOTION CONTROL ADJUSTMENT
f) Start engine. Brake must be engaged and motion control levers out to
start engine. Operator does not have to be in the seat because of the
jumper wire being used. Run engine at full throttle and release brake.
g) The reverse indicator spring must be correct before the following
adjustments can be made. See Section 5.2.12.
NOTE: The motion control lever needs to be in neutral while making
any necessary adjustments.
The left rod assembly controls the left wheel and the right rod assembly
controls the right wheel.
h) Bring the RH motion control lever into the neutral position. Adjust RH pump
control rod length by rotating the double nuts on the rod in the appropriate
direction until the wheels slightly creep in reverse. (See Figure 16) Move
the motion control lever to the reverse position and while applying slight
pressure to the lever allow the reverse indicator spring to bring the levers
back to neutral. The wheel must stop turning or slightly creep in reverse.
i) For Serial Nos. 369,999 and lower: Repeat steps e) through h) for the LH
side of unit.
For Serial Nos. 370,000 and higher: Bring the LH motion control lever into
the neutral position. Adjust the LH pump control rod length by rotating the
tracking adjustment knob in the appropriate direction until the wheels
slightly creep in reverse. Move the notion control lever to the reverse
position and while applying slight pressure to the lever allow the reverse
indicator spring to bring the levers back to neutral. The wheel must stop
turning or slightly creep in reverse. See Figure 16.
j) Shut off unit. Remove jumper wire from wire harness connector and plug
connector into seat switch.
Caster pivot bearings pre-load adjustment.
a) Remove dust cap from caster and tighten
nyloc nut until washers are flat and back
off 1/4 of a turn to properly set the pre-
load on the bearings. If disassembled,
make sure the spring washers are
reinstalled as shown in Figure 17.
www.mymowerparts.com
FIGURE 16
CASTER ADJUSTMENT
- 42 -
FIGURE 17