Base Assy - Toshiba TECRA R10 Maintenance Manual

4 Replacement Procedures

4.11 BASE ASSY

Removing the BASE ASSY
To remove the BASE ASSY, follow the steps below and refer to Figure 4-13 to 4-15.
1. Remove the INSU LCD HNS UP from the COVER ASSY
2. Disconnect the LCD harness from the connector CN5000 on the system board.
3. Remove the following screws securing the COVER ASSY.
• M2.5×6C
INSU LCD HNS UP
NOTE: The circled number shows the order to drive the screws.
4-26 [CONFIDENTIAL]
FLAT HEAD screw
LCD harness
CN5000
Figure 4-13 Removing the BASE ASSY (1)
×2
M2.5x6C FLAT HEAD
TECRA R10 Maintenance Manual (960-708)
4.11 BASE ASSY