Toshiba TECRA R10 Maintenance Manual page 259

Hide thumbs Also See for TECRA R10:

Table of Contents

4.13 HDD/SSD

Removing the moving HDD/SSD

To remove the HDD/SSD, follow the steps below and refer to Figure 4-18.

1. Disconnect the HDD/SSD FPC from the connector CN1900 on the system board.

2. Remove the HDD/SSD from the slot.

3. Disconnect the HDD/SSD FPC from the HDD/SSD connector.

Installing the HDD/SSD

To install the HDD/SSD, follow the steps below and refer to Figure 4-18.

1. Connect the HDD/SSD FPC to HDD/SSD connector.

2. Set the HDD/SSD in the slot in place.

3. Connect the HDD/SSD FPC to the connector CN1900 on the system board.

TECRA R10 Maintenance Manual (960-708)

Figure 4-18 Removing the HDD/SSD

4 Replacement Procedures

[CONFIDENTIAL]

Show Quick Links

Chapters

Table of Contents