Wireless Lan Card; System Board; Lcd Assembly/Base Assembly - Toshiba QOSMIO G50 Maintenance Manual

4 Replacement Procedures
4

4.15 LCD assembly/Base assembly

Removing the LCD assembly/Base assembly
The following describes the procedure for removing the LCD assembly/Base assembly (See
Figure 4-31 and 4-32).
1. Disconnect the wireless LAN antenna cables from the connector on the wireless
LAN card and release them from the guides.
2. Disconnect the LCD cables from the connector CN5310 and CN5311 on the system
board and release them from the guides.
3. Disconnect the GPS cable or Wireless USB cable from the connector on the GPS or
Wireless USB and release them from the guides.
4. Remove the following screws securing the base assembly.
•
M2.5×6B
M2.5x6B FLAT HEAD
Guide
GPS cable or Wireless USB cable
4-48 [CONFIDENTIAL]
FLAT HEAD screw
LCD cable
GPS or Wireless USB
Figure 4-31 Removing the base assembly (1)
4.15 LCD assembly/Base assembly
×3
M2.5x6B FLATHEAD
Wireless LAN antenna cable
CN5310
CN5311
Guide
QOSMIO G50 Maintenance Manual (960-683)

Wireless LAN card