4.21 RGB HARNESS
4.21 RGB HARNESS
Removing the RGB HARNESS
To remove the RGB HARNESS, follow the steps below and refer to Figure 4-29.
1. Remove the following screws to remove the RGB HARNESS from the slot.
• #4-40×5C
2. Peel the INSU RGB HNS fixing the RGB HARNESS to the DC-FAN.
3. Disconnect the RGB HARNESS from the connector CN9510 on the system board.
TECRA R10 Maintenance Manual (960-708)
UNIFIED screw
RGB HARNESS
Figure 4-29 Removing the RGB HARNESS
4 Replacement Procedure
×2
#4-40x5C UNIFIED
INSU RGB HNS
CN9510
[CONFIDENTIAL]
4- 51