Deleting Autodial Memory Locations; Redial; Store & Send - Kenwood TK-7100H Service Manual

6.2.9.3 Deleting Autodial Memory Locations:

You can delete Autodial Memory locations by
overwriting the DTMF Code.
1 Press the [#] key.
2 Press the [#] key again.
3 Enter the Autodial Memory number you want to
clear (1 ~ 9).
Example
To delete Autodial Memory location 1, press [#],
[#], [1].

6.2.10 Redial

You can use this function by programming the
Autodial.
Redial re-transmits the last DTMF Code that was
sent.
Redial operation functions the same as Autodial.
Press the [0] key to display the last transmitted DTMF
Code, then press the PTT switch to transmit the code.
Note: You cannot use this function when transmitting a
DTMF Code using PTT ID.
6.2.11 Store & Send
This function allows you to automatically transmit the
stored DTMF Code using the keypad.
1 Enter the DTMF Code via the keypad.
(In this case, keys [1], [2], and [3] are pressed.)
2 Press the PTT switch to transmit the DTMF Code.
3 Press the [*] key to enter Autodial mode when
using the Autodial and Store & Send function at
the same time.
4 Press the [*] key again to enter Store & Send
mode.
5 Press the [#] key.
6 Press the [*] key to enter "#" as a first digit of the
code.
7 Press the [#] key to enter Store & Send entry
mode.
Example
• To enter "*123":
Press [*], [*], [1], [2], [3].
• To enter "#123":
Press [*], [#], [1], [2], [3].
You cannot use the Keypad Auto PTT function and
Store & Send function at the same time. The Keypad
Auto PTT box is greyed out when the Store & Send
function is enabled, and vice-versa.
6 DTMF
21