Table of Contents
Advertisement
1 Basic Information
1.1
Turning Power ON
1 Turn the transceiver ON.
• A beep sounds.
Note: The initial screen appears when turning on the
transceiver, then the characters programmed in the
Power On Text appear.
1.2
Volume Adjustment
You can adjust the volume using the [VOL UP] and
[VOL DOWN] keys.
1.3
Group/Channel Selection
Selecting a Group:
Press the keys programmed as [Group Up] or
[Group Down] to move to the desired Group.
Note: When the transceiver reaches the maximum Group
Number, pressing the [Group Up] key will cause the
transceiver to move to the lowest Group number.
When the transceiver reaches the lowest Group
Number, pressing the [Group Down] key will cause the
transceiver to move to the maximum Group number.
Note: The Roll Over Tone beeps when the transceiver
reaches the lowest Group Number.
Selecting a Channel:
Press the [CH UP] and [CH DOWN] keys to move
to the desired Channel.
Note: When the transceiver reaches the maximum Channel,
pressing the [CH Up] key will cause it to move to the
lowest Channel. When the transceiver reaches the
lowest Channel, pressing the [CH DOWN] key will
cause it to move to the maximum Channel.
Note: The Roll Over Tone beeps when the transceiver
reaches the lowest Channel.
Roll Over Tone
Group1(Channel1)
Group2(Channel2)
Roll Over Tone
1.4
Communicating
1.4.1 Transmitting a QT/DQT Code
The transceiver transmits QT/DQT codes when
programmed in the channels of the radio and the PTT
switch is depressed.
The receiving party's QT/DQT must be the same as
the transmitting party's QT/DQT in order to receive
tha call.
1.4.2 Receiving QT/DQT Codes
To receive a call on a channel where QT/DQT codes
are used, the received QT/DQT must be the same as
the QT/DQT programmed in the transceiver.
1.5
1.5.1 User Mode
The transceiver enters User Mode when turning the
transceiver ON. User Mode is the most frequently
used mode.
1.5.2 Clone Mode
The transceiver enters Clone Mode when it is turned
ON while pressing the [CH DOWN] key.
Refer to "11 Clone Mode" for details.
1.5.3 Self Programming Mode
The transceiver enters Self Programming Mode when
it is turned ON while pressing the [MON] key.
Refer to "12 Self Programming Mode" for details.
1.5.4 Firmware Version Information
The transceiver displays the Firmware version when
it is turned ON while pressing the [ ] key.
Refer to "10 Firmware Version Information Mode" for
details.
1.5.5 PC Mode
Group**(Channel**)
The PC Mode includes reading or writing data using
the FPU (KPG-80D). It also contains the Test Mode in
the FPU.
The transceiver enters PC Mode when switching the
mode to Test Mode or reading/ writing data using the
FPU.
Mode Entry
Mode
5
Advertisement
Table of Contents
