Yamaha VMAX 2009 Service Manual page 231

a
2
L LLL L LLL L L LLL L
5. Install:
• Left handlebar switch "1"
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
1
6. Install:
• Clutch master cylinder assembly
• Clutch master cylinder holder "1"
Clutch master cylinder holder
bolt
14 Nm (1.4 m·kgf, 10 ft·lbf)
TIP
• The clutch master cylinder holder "1" has a
punch mark "a" to distinguish it from the front
brake master cylinder holder "2".
• Align the mating surfaces of the clutch master
cylinder holder with the punch mark "b" on the
handlebar.
• First, tighten the upper bolt, then the lower bolt.
1
1
L LLL L L LLL L L LLL L
b 1
a
a
2
1
LLL
7. Install:
• Throttle grip
• Throttle cables
• Throttle cable housings "1"
TIP
Align the projection "a" on the throttle cable
housing with the hole "b" in the handlebar.
1
8. Install:
• Right handlebar switch "1"
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" on the handlebar.
9. Install:
• Front brake master cylinder assembly
• Front brake master cylinder holder "1"
4-66
HANDLEBAR
b
a
b
1
1
Front brake master cylinder hold-
er bolt
14 Nm (1.4 m·kgf, 10 ft·lbf)
b
1
a