Yamaha VMAX 2009 Service Manual page 117

1. ECU (engine control unit)
2. Wire harness
3. Lean angle sensor
4. Positive battery lead (to positive battery terminal)
5. Main fuse lead
6. Starter relay lead
7. Battery
8. Main fuse
9. Starter relay
10. Brake hose (hydraulic unit to left front brake
caliper)
11. Brake hose (front brake master cylinder to
hydraulic unit)
12. Ignition coil sub-wire harness 1
13. Sub-wire harness
14. Positive battery lead (to wire harness)
A. To wire harness
B. To positive battery terminal
C. Route the leads that branch off from the wire
harness through the slit in the battery box heat
shield.
D. Route the main fuse lead and starter relay lead
between the positive battery lead and the battery
box.
E. Wrap the battery box heat shield around the brake
hose (front brake master cylinder to hydraulic unit)
and brake hose (hydraulic unit to left front brake
caliper) as shown in the illustration.
F. Make sure that the positive battery lead (to positive
battery terminal) is not pinched between the ECU
tray and the battery box.
2-64
CABLE ROUTING