Yamaha VMAX 2009 Service Manual page 107

1. Radiator fan motor relay
2. Headlight relay
3. Relay unit
4. Fuse box 1
5. Turn signal/hazard relay
6. Rear wheel sensor coupler
7. Wire harness
8. Gas cylinder hose (rear shock absorber assembly)
9. O sensor lead
2
10. Brake hose (rear brake master cylinder to
hydraulic unit)
11. Rear brake light switch lead
12. Rear wheel sensor lead
13. Brake hose (hydraulic unit to rear brake caliper)
14. EXUP cables
A. Route the rectifier/regulator leads, rear left turn
signal light lead, rear right turn signal light lead,
tail/brake light lead, and license plate light lead
between the rear frame and mud guard 1.
B. Fasten the wire harness at the split in the harness
with the holder. Face the catch of the holder
outward.
C. Insert the projection on the plastic locking tie into
the hole in the right side cover from the inside, and
then fasten the rear brake light switch lead, rear
wheel sensor lead, and O
D. Cross the brake hose (hydraulic unit to rear brake
caliper) in front of the brake hose (rear brake
master cylinder to hydraulic unit).
E. To hydraulic unit assembly
F. Route the brake hose (hydraulic unit to rear brake
caliper) and brake hose (rear brake master cylinder
to hydraulic unit) through the cutout in the fuel tank
protector.
G. Route the EXUP cables to the outside of the gas
cylinder hose (rear shock absorber assembly).
sensor lead with the tie.
2
2-54
CABLE ROUTING