Assembling The Front Wheel - Yamaha VMAX 2009 Service Manual

M MMM M MMM M M MMM M
a. Hold the dial gauge at a right angle against
the wheel sensor rotor surface.
b. Measure the wheel sensor rotor deflection.
TIP
Do not touch the surface of the rotor magnet with
a sharp object.
c. If the deflection is above specification, re-
move the sensor rotor from the wheel, rotate
it by one or two bolt holes, and then install it.
Wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
ECA2S31010
NOTICE
Replace the wheel sensor rotor bolts with
new ones.
d. If the deflection is still above specification, re-
place the wheel sensor rotor.
L LLL L LLL L L LLL L
EAS21960

ASSEMBLING THE FRONT WHEEL

ECA2S31008
NOTICE
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
MMM • If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearings
M MMM M MMM M
a. Install the new wheel bearing (right side).
ECA2S31011
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
LLL
L LLL L LLL L
2. Install:
• Front wheel sensor rotor
4-16
FRONT WHEEL
New
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
Front wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
M MMM M MMM
L LLL L LLL