Fujitsu ScanSnap S510M Operator's Manual page 245

7. Remove the pick roller from its shaft.
Pull out the shaft from the pick roller while lifting up its tab.
If you push up the pick roller tab using your fingernail, your fingernail
ATTENTION
may be hurt or get chipped. If you cannot push it up successfully with
your fingernail, you can use a paper clip to push up the pick roller tab.
8. Attach a new pick roller to the shaft.
Insert the shaft aligning the protrusion with the slot on the new pick roller.
Tab
Shaft
Pick roller
2
Protrusion
Shaft
Slot
ScanSnap S510M Operator's Guide
9.3 Replacing the Pick Roller
1
Pick roller
9
223