Control Quick Guide; First Use; Ice - U-Line U-3018CLRS-00A Quick Start Manual

QUICK START GUIDE

Control Quick Guide

Actual Display:
Control Function Guide:
FUNCTION
OFF
ON
Adjust lighting
Customer menu
Service menu

First Use

All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default setting. Follow the on screen prompt for
language selection and temperature units.
To turn the unit off, press
release. The display will show a countdown to switching the
unit off.
To power your unit on, simply press
immediately switch on.
Up
Down
COMMAND
Press and hold
Press and release
Press to adjust lighting
Press and hold for 5 seconds
Press and hold for 5 seconds
or
and hold for 5 seconds and
. The unit will
ICE PRODUCTION
U-Select Lighting
DISPLAY/OPTIONS
Display will count down from 5 to off.
Unit will come on immediately.
Press
Press
Press

Ice

ICE CUBE THICKNESS ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Remove all ice from the storage bin.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
The ice cube thickness is factory set for best overall
performance. The factory setting "0" is designed to
maintain an ice bridge of approximately 1/16" to 1/8"
(1.6 mm to 3.2 mm) under normal conditions, resulting in
a dimple of approximately 1/4" to 1/2" (6.4 mm to
8
Zone Toggle
Select
Power
or to set low, medium or high.
or to scroll through menu.
or to scroll through menu.
u-line.com