Table of Contents
Advertisement
General Troubleshooting
Symptom
Auto shut off
Breaker/Fuse keeps
blowing
Device has no power
Fixture is not
responding
Fixture is on but there
is no movement to the
audio
Light will not come on
after power failure
Loss of signal
No light output
If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support
at the location below.
Contact Us
W o r l d W i d e
General Information
Technical Support
World Wide Web
DIAMONDstrip™ Mini User Manual
Solution(s)
Check fan thermal switch reset
Check total load placed on device
Check for power on Mains.
Check device's fuse. (internal and/or external)
Check DMX settings for correct addressing
Check DMX cables
Check polarity switch settings
Make sure you have the correct audio mode on
Adjust sound sensitivity knob
Some discharge lamps require a cooling off period
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power
cables or black lights.
Check fuse
Call service technician
CHAUVET
3000 North 29
Hollywood, FL 33020
voice:
954.929.1115
fax:
954.929.5560
toll free: 800.762.1084
CHAUVET
3000 North 29
Hollywood, FL 33020
voice:
954.929.1115 (Press 4)
fax:
954.929.5560 (Attention: Service)
www.chauvetlighting.com
th
Court
th
Court
15
1/26/2010 2:58 PM
Advertisement
Table of Contents
