JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®...
Page 3
5. Do not use this tool for other than its intended use. If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use.
Net Weight (lbs.) ............................1 The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
2. Place four or five drops of air tool oil* into the air inlet (Figure 3). [*NOTE: Air tool oil not provided. It may be purchased from your JET dealer, or is available at most major hardware and tool stores. SAE #10 weight oil or sewing machine oil may be used as a substitute.
3. Re-connect the air. Run the die grinder 2. Set air pressure to 90 psi. without load for a few seconds to distribute the oil throughout the tool. Excess air pressure and/or unclean air will shorten the tool’s life and 4.
Page 7
To order parts or reach our service department, call 1-800-274-6848 Monday through Friday (see our website for business hours). Having the Model Number and Serial Number of your tool available when you call will allow us to serve you quickly and accurately.