Related Manuals for Jet JAT-410
Summary of Contents for Jet JAT-410
- Page 1 Pneumatic Micro Die Grinder #505410, JAT-410 Operation Manual M-505410 Edition 1 05/2019 427 New Sanford Road LaVergne, TN 37086 Ph.: 800-274-6848 www.jettools.com Copyright © 2019 JET...
- Page 2 15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16.
- Page 3 To reduce 32. Do not lubricate the tool with combustible your exposure to these chemicals, work in a liquids, such as kerosene, diesel or jet fuel. well-ventilated area and work with approved safety equipment, such as dust masks that are 33.
-
Page 4: About This Manual
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 5: Tool Specifications
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 6: Setup And Assembly
(not included) into collet, and retighten collet nut securely with wrench. Blow out air line to remove any dirt or moisture, then connect air supply hose to tool. Set air pressure to 90psi. JAT-410 Micro Die Grinder ... - Page 7 (See also “Troubleshooting” Use a light oil containing rust inhibitors, such as section.) SAE #10. Many JET air tools have integral oil reservoirs, which should be kept filled when in-line Contaminated air such as a dirty air system oilers are not used.
- Page 8 Figure 2 Recommended arrangement of air piping and air line system JAT-410 Micro Die Grinder ...
-
Page 9: Troubleshooting Jet
® Troubleshooting JET Air Tools Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed. -
Page 10: Warranty And Service
Shop Tools; Warehouse & Dock products; Hand Tools: Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. - Page 11 ...
- Page 12 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com JAT-410 Micro Die Grinder ...