Related Manuals for Jet JAT-420
Summary of Contents for Jet JAT-420
- Page 1 Pneumatic Mini Die Grinders #505420, JAT-420 Combo Pack Operation & Maintenance Manual M-505420 Edition 2 11/2018 427 New Sanford Road LaVergne, TN 37086 Ph.: 800-274-6848 www.jettools.com Copyright © 2018 JET...
-
Page 2: Safety Warnings
Do not use this tool for other than its intended not carry tool by the air hose. use. If used for other purposes, JET disclaims 16. Air hose may cause tripping hazards; keep any real or implied warranty and holds itself hose away from traffic areas. - Page 3 31. Do not lubricate the tool with combustible well-ventilated area and work with approved liquids, such as kerosene, diesel or jet fuel. safety equipment, such as dust masks that are specifically designed to filter out microscopic 32.
-
Page 4: About This Manual
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 5: Tool Specifications
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 6: Setup And Assembly
1). If an in-line oiler is not being used, add 4 throttle lever and safety lever pivots, and work or 5 drops of air tool oil (not included) into the lever to distribute the oil. air inlet. 505420 JAT-420 Mini Die Grinder Combo Pack... - Page 7 Lubrication Information Use a light oil containing rust inhibitors, such as SAE #10. Many JET air tools have integral oil If the air tool is not performing according to reservoirs, which should be kept filled when in-line specifications, the following are among the most oilers are not used.
- Page 8 Figure 2 Recommended arrangement of air piping and air line system 505420 JAT-420 Mini Die Grinder Combo Pack...
- Page 9 Troubleshooting JAT-420 Mini Die Grinders Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
-
Page 10: Warranty And Service
Canada by JPW Industries, Inc. NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. - Page 12 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com 505420 JAT-420 Mini Die Grinder Combo Pack...