Samsung SNP-6200 User Manual page 52

network connection and setup
3. When done, click [Save Settings].
Your settings will be saved.

M
Above sample instructions are based on the CISCO's Broadband Router (Model: LINKSYS).

The settings may differ depending on the connected Broadband Router model.
For more information, refer to the user manual of the applicable router.
Setting up Port Range Forward for several network cameras
When several network cameras are connected to one Broadband Router device, you
should forward the TCP 943 port of the router to the TCP 943 port of a connected camera.

J
If you don't set properly the TCP 943 port of the router, you cannot get any video stream from the
web page of the camera.
• TCP 943 port is a port for the Silverlight policy server of a camera.
• You can set a rule of Port Forwarding on the Broadband Router device through its
configuration web page.
• You cannot change the Silverlight policy server port of a camera.
• You can change the ports of the camera except the policy server port through its
configuration web pages.
When Camera1 and Camera2 are connected to a router :
User
Start End
943 943
3000 3000
3001 3001
4520 4520
4521 4521
8080 8080
8081 8081
52_ network connection and setup
Internet
Broadband Router
Protocol
TCP 192.168.1.100
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
IP Address
Camera1 (192.168.1.100)
HTTP Port 8080
VNP Port 4520
RTSP Port 3000
Policy Server Port 943
Camera2 (192.168.1.101)
HTTP Port 8081
VNP Port 4521
RTSP Port 3001
Policy Server Port 943