Safety Label Location; Setting Up Your New Tiller - Honda FG110 Owner's Manual

SAFETY LABEL LOCATION

The label shown here contains important safety information. Please
read it carefully. This label is considered a permanent part of your
tiller. If the label comes off or becomes hard to read, contact your
authorized Honda tiller dealer for a replacement.

SETTING UP YOUR NEW TILLER

Unpacking
1. Carefully remove the tiller
from the carton.
2. Unfold the tiller upper
handle to the operating
position as shown. Be
careful not to crimp or
pinch the engine switch
wires and throttle cable.
3. Tighten the handlebar
knobs to secure the
handle in the correct
operating position.
HANDLEBAR
KNOBS
Engine Oil
The tiller is shipped WITHOUT OIL in the engine.
All Honda engines are run at the factory prior to packaging. Most of
the oil is removed prior to shipment; however, some oil remains in the
engine. The amount of oil left in the engine varies.
1. Working on a
level surface, tip
the tiller on its
carrying
handlebar as
shown.
2. Remove the oil
filler
cap/dipstick.
3. Slowly add the
recommended
oil (included in
the box) to the
bottom edge of
the oil filler hole.
Do not overfill,
as the engine oil
CARRYING
tank capacity is
HANDLEBAR
small.
NOTICE
Running the engine with too little or too much oil can cause engine
damage. This type of damage is not covered by the
DISTRIBUTOR'S LIMITED WARRANTY (page 21).
4. Screw in the oil filler cap/dipstick securely.
Fuel
Refer to page 12.
Before Using Your Tiller
Before using the tiller, all tiller operators must read the following
chapters and sections:
• TILLER SAFETY (see page 2).
• CONTROL LOCATIONS (see page 4).
• BEFORE OPERATION (see page 4).
• OPERATION (see page 5).
• MAINTENANCE SCHEDULE (see page 8).
Please Register Your Tiller
If your dealer did not collect registration information from you, please
take a few minutes and register your purchase with Honda. This
allows us to contact you with any important updates regarding your
tiller. Your information will remain confidential. It will not be released
to any other company or organization. Please note registration is not
required to obtain warranty service.
You can register by completing and mailing the included registration
card, or go online to www.hondapowerequipment.com and click on
Product Registration.
OIL FILLER
CAP/DIPSTICK
OIL FILLER
HOLE
3