Fujitsu 4312 FA Operating Manual page 21

Carry out auto-adjustment of the monitor for the current resolution
With the AUTO button you can start the auto-adjustment for the current resolution. During the auto-
adjustment the display Auto adjustment is shown.
During auto-adjustment the functions Fine, Coarse and Position are carried out (see Image Lock,
Horizontal and Vertical adjustment window). For this purpose a screen display must be present
which has a few light dots in the first and last column and in the first line. The Windows desktop
usually fulfills this condition.
When changing the monitor controller to a mode (resolution and refresh rate) in which the monitor
has not been operated up until then, the monitor automatically executes the Auto adjustment function.
Should you be dissatisfied with the results of the auto adjust function, then set the basic
i
setting of the monitor with the floppy disk provided.
Monitor settings using the OSD menu
To set the OSD menu, perform the following steps:
Ê
Press the MENU button to activate the OSD menu.
The main menu appears on the screen with icons for the setting functions.
Brightness
S26361-K841-V150-1-5E19
The last icon set is marked (in this case
Brightness). At the same time, the corresponding
K
setting window appears.
Ê
i
The displayed setting window changes when
changing from one symbol to another.
80
Ê
Ê
Colour monitor 4312 FA
If necessary, use the - or + button to mark
another icon, e.g. Contrast.
Press the MENU button to activate the
highlighted icon.
Use the buttons - or + (in accordance with
the displays in the menu) to make
changes.
English - 13