Brushing Modes; Brushing Technique - Braun Oral-B TRIUMPH User Manual

Both timers memorise the elapsed brushing
time, even when the handle is briefly switched
off during brushing. Only when pausing longer
than 30 sec. the timer resets to the initial
starting point.
The «Count Up Timer» displays your actual
brushing time. The «Count Down Timer»
indicates the remaining brushing time. Starting
with «2:00» minutes, it goes down to «0:00».
When brushing longer than two minutes, it
automatically changes to the «Count Up Timer».
Your toothbrush comes with the «Professional
Timer» and the «Count Up Timer» activated.
If you wish to change these settings, proceed
as follows:
• Press and hold the mode button (c) until the
SmartGuide display unit (k) shows «:30» and
«timer».
3 sec. 3 sec.
• By briefly pressing the on/off button (b), switch
to the «2-Minute Timer». Confirm your choice
by pushing the mode button.
• This will lead you directly to the «Count Up
Timer» display ("up" and "timer" will be
shown). Switch to the «Count Down Timer» by
pressing the on/off button and confirm it with
the mode button.
Please note: it is normal that the handle display
shows two flashing bars when operating in the
timer setting mode.
12
Brushing

Brushing modes

Your toothbrush offers different brushing modes
for varying oral care needs:
«Clean» – Exceptional cleaning of
«Sensitive» – Gentle, yet thorough
«Massage» – Gentle stimulation of gums.
«Polish» – Exceptional polishing
• When pressing the on/off button your
toothbrush automatically starts in the «clean»
mode.
• To switch to the other modes, successively
press the mode button.
• To return from any mode to the «clean» mode,
press and hold the mode button.
• To turn your brush off, press the on/off button.
Please note: the «polish» mode is best used
with an Oral-B Pro White brush head. Once the
Oral-B Pro White is attached, press the on/off
button and your toothbrush automatically starts
in the «polish» mode (please see «Brush
heads»).

Brushing technique

• Guide the brush head slowly from tooth to
tooth.
• Hold the brush head in place for a few
seconds before moving on to the next tooth.
• Brush the gums as well as the teeth, first the
outsides, then the insides, finally the chewing
surfaces.
• Do not press too hard or scrub, simply let the
brush do all the work.
When you finish brushing, the total brushing
time will be displayed for 30 seconds before the
display switches back to the time mode. To
directly get to the time mode, clear the brushing
time display by pushing the mode button.
teeth and gums.
cleaning for sensitive areas.
for naturally white teeth for
occasional or everyday use.