Operating The System - Scantronic 8136UK-50 Installation And User Manual

installer Setting
User 00
User 96
User 97
User 98
User 99

Operating the System

Users can set and unset the system from a keypad using one of the following
key sequences:
In order to:
Set the system
See why system will
not set. (Display shows
"Setting Stopped"))
Turn the system off
Set individual Level
Turn individual level off
Set individual area
Switch off the Bells
Read log
Reset system
Note: When a user has authority to set more than one Level, but does not
specify which Level to set, the system chooses the first Level in each Parti-
tion that the user has authority to set. For example: a user has access to
Partitions 1 and 2. Partition 1 can be set by Level A (Areas 1 and 2) and
Level B (Area 1). Partition 2 can be set by Level C (Areas 3 and 4) and Level
D (Area 3). If the user keys in [Access Code] + [Enter] then the system sets
Level A and Level C (equivalent to Areas 1, 2, 3 and 4).
40 of 44
The Installer or Engineer.
The central station when it carries out a remote
reset.
The control panel when it performs an internal
check (watchdog).
Any keyswitch.
<Downloader> when it connects to the system.
Key in:
ACCESS CODE + ENTER
A (repeat to see all messages)
ACCESS CODE + ENTER
ACCESS CODE + LEVEL KEY + ENTER
ACCESS CODE + LEVEL KEY + ENTER
ACCESS CODE+LEVEL KEY+AREA NO.+ENTER
ACCESS CODE + ENTER
ACCESS CODE +MENU + 9 +
ENTER + ENTER
ACCESS CODE + ENTER
496339 Issue 4
The system will do this:
Exit tone starts. Leave
premises. System sets the
highest security Level.
Display shows reasons for
stop. Check detector
zones listed in display. Try
to set system again.
Display shows time and
date. System is ready to
use.
Part sets the system.
Display shows time and
date. System is ready to
use.
Bells and sounder cease.
The display shows first
detector zone to alarm.
Displays the events it has
recorded. Press A to see
earlier events, Press B to
see later events
Display shows time and
date. System is ready to
use.
8136