Testing Fall Detection - ADT Health Fall Detection Pendant User Manual

Testing Fall Detection

Please have your complete system near you at the time of testing.
1. Drop the Fall Detection Pendant from a height of approximately 18 inches. The
pendant takes 20 to 30 seconds to interpret the movement and determine if an
actual fall has occurred. If it determines that a fall has occurred:
The Pendant sends a signal to the Base Station.

The Pendant sounds a series of beeps and the light flashes red for 20

seconds.
The Base Station says "FALL DETECTED, PRESS AND HOLD BUTTON TO

CANCEL."
2. Do not pick up the pendant before the test is completed, as it may interpret this
as normal movement and cancel the test call.
Fall Detection Pendant User Guide 7