SATO GL4xxe Configuration Instructions page 5

2. Configuring Wireless LAN connection on GL4xxe
1. Before starting configuration, make sure your printer has the Wireless Ethernet
interface card installed and the printer is powered on. (Please note, settings are
stored on the printer, NOT on the interface card like our other model printers).
2. Press the "LINE" key to take the printer offline.
3. Scroll down to "ADVANCE MODE" and press
the "ENTER" key.
4. Scroll up to "Admin User" and press "ENTER".
Highlight the option to "Enable" and press
"ENTER". If the display says "Enter Switch
Locked", press the down and "ENTER" key at
the same time to unlock the menu and then you
should be able to press "ENTER" on "Enable"
for Admin User.
5. Press the "FUNCTION" key to bring the menu
up and use the arrow key to select
"INTERFACES" and press the "ENTER" key.
6. If using DHCP, scroll to "WLAN ADDRESS"
and press "ENTER". Select "DHCP" and make
sure it is set to "Enabled". If you want to set up
a static address for the printer, make sure
"DHCP" is set to "Disabled" then scroll to
"WLAN ADDRESS" and press "ENTER". The
next steps will guide you through a static
address setup.
www.satoamerica.com