Pro-Form 11.0 TT User Manual page 17

16. Note: If assembled on a smooth surface, the
treadmill may roll forward during this step.
Raise the Frame (56) to the upright position.
IMPORTANT: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 18 is completed.
Remove the two 5/16" x 3/4" Screws (25) from
the Latch Crossbar (38).
Orient the Latch Crossbar (38) as shown. Make
sure that the "This side toward belt" sticker
(E) is facing the treadmill. Attach the Latch
Crossbar to the brackets on the Frame (56) with
the two 5/16" x 3/4" Screws (25) that you just
removed and two 5/16" Star Washers (11).
17. Remove the 5/16" Nut (12) and the 5/16" x 1 3/4"
Bolt (6) from the bracket on the Base (94).
Orient the Storage Latch (53) as shown.
Attach the lower end of the Storage Latch (53)
to the bracket on the Base (94) with the 5/16"
x 1 3/4" Bolt (6) and the 5/16" Nut (12). Do not
overtighten the Nut; the Storage Latch must
be able to pivot.
Then, raise the Storage Latch (53) to a vertical
position, and remove the tie.
16
11
25
56
17
Tie
12
17
Brackets
E
38
11
25
53
94 6