Pro-Form 11.0 TT User Manual page 18

18. Remove the 5/16" Nut (12) and the 5/16" x 2 1/4"
Bolt (3) from the bracket on the Latch Crossbar
(38).
Align the upper end of the Storage Latch (53)
with the bracket on the Latch Crossbar (38).
Insert the 5/16" x 2 1/4" Bolt (3) through the
bracket. This will push a spacer (F) out of the
other end. Discard the spacer.
Attach the Storage Latch (53) with the 5/16" x
2 1/4" Bolt (3) and the 5/16" Nut (12). Do not
overtighten the Nut; the Storage Latch must
be able to pivot.
Then, lower the Frame (56) (see HOW TO
LOWER THE TREADMILL FOR USE on page
28).
19. Firmly tighten the six 3/8" x 4" Screws (7) (only
one side is shown).
Press the Left Base Cover (82) and the Right
Base Cover (83) onto the Base (94).
20. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 30 and 31). Note: Extra parts may be
included.
18
12
F
56
19
82
18
38
3
53
94
83
7