Installation Instructions; Removing Transit Bolts; Location Of Washer - Daewoo DWDNU1221 Instruction Manual

INSTALLATION INSTRUCTIONS

Removing transit bolts

1. Before operating the washer, remove the
transit bolts(x3) along with the rubber
around them.
• If the bolts are not removed, it may cause
excessive noise, vibration or malfunction.
3. Close the holes with the sticker holders supplied.

Location of washer

• Check the location where the washer will be installed. Make sure you have everything
necessary for correct installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any times.
• Install the washer on the horizontal, solid, level floor.
If the washer is installed on an unsuitable floor, it could make
considerable noise, vibrate severely and cause a malfunction. If the
washer is not level, adjust leg up or down for horizontal installation.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
• Leave some space around the machine (right & left : 2cm, rear : 10cm).
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 3mm.
DWDNU1221(영)_영국향.indd 5
2. Unscrew the 3 bolts with a 10mm hex
wrench or spanner or cross-tip screwdriver.
Do not discard the bolts.
• When the appliance is transported, the
transit bolts will need to be re-used.
5
Drain Hose
Washer
Laundry
Tub
approx.
2cm
15. 3. 11. 오후 2:54