Battery Installation And Charging - AT&T CRL82112 User Manual

Getting started

Battery installation and charging

Install the battery as shown below.
screen indicates the battery status (see the table below). If necessary, place
the handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger when not in
use. The battery is fully charged after 10 hours of continuous charging.
the table on page 77 for battery operating times.
If the screen shows Place in charger and
handset without interruption
enough charge to use the telephone for a short time.
summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or shows
Place in charger and
(flashing).
The screen shows Low
battery and (flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
for at least 30 minutes to give the handset
Battery status
Battery has no or very little
charge. The handset cannot
be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert
the supplied battery
with the label THIS
SIDE UP facing up as
indicated.
Once you have installed the battery, the
flashes, you need to charge the
6
The following table
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
See