Assembling The Base - Hunter Ernest Hemingway Series Owner's Manual

Step Title
Cover
Plate
Screw
Power
Cord
Step 3-2:
3-2. Thread the power cord through the lower pole section
and slide the lower pole onto the base stand. Align the
holes in the lower pole segment with the holes in the
base stand and securely install two lower pole bolts
with nuts to stabilize.
Hardware Needed:
Lower Pole Nut
06552-02-247
(x 2)
Tab
3 • Assembling the Base
Hardware Needed:
Cover Plate
Screw
74506-59-247
(x 4)
Channel
Hardware Needed:
Lower Pole Bolt
06551-10-247
(x 2)
Hardware Needed:
Tab Screw
74513-54-247
(x 2)
Screw
42746-01 • 04/26/07 • Hunter® Fan Company
3-1. Guide the power cord through the channel
and install the cover plate over the power cord
using four screws. Be sure the power cord is not
pinched between the channel and the cover plate.
You will need the assistance of at least one other
person to assemble the base and skirt sections.
Lower
Steps 3-3 - 3-4:
3-3. Being careful to not damage the fan finish, slide the
base cover onto the lower pole and let it rest on the
base stand.
3-4. Holding both the base stand and base cover,
carefully tilt the base assembly and rest the
assembly on its side to access the bottom of the
base. Align the two tabs on the base cover with the
two holes in the base stand. Install two screws to
secure the base cover to the base stand.

Step 3-1:
Lower
Pole
Section
Pole
Bolt
Lower
Pole
Nut