Assembling The Skirt - Hunter Ernest Hemingway Series Owner's Manual

Note: This fan should be assembled in an open,
level area with a solid ground surface large
enough for the assembled fan.
2-1. Locate the base stand and place it on the ground at the location
where the fan will be operated.
2-2. Identify the skirt section with the 4
small screw holes around the power
cord channel and a notch in the inner
edge. Align the four holes in the skirt
section with the holes in the base
stand where the power cord is located,
then align the notch in the skirt
section with the raised tab on the base
stand. Partially install four base bolts
to attach the skirt section to the base stand. To ensure proper
spacing, do not tighten the bolts until all have been partially
installed.
Note: The remaining three skirt sections are identical and may be
installed in any order.
2-3. Align the four holes in the next skirt section with four holes in the base
stand. Partially install four base bolts. Repeat for the remaining skirt
sections.
CAUTION: Do not attempt to assemble fan without all four skirt sections. The fan may fall if a skirt section is not installed.
Skirt
Section
Skirt Bolt
2 • Assembling the Skirt
Hardware Needed:
64193-02-247
Hardware Needed:
Skirt Bolt
06548-01-247
(x 16)
Skirt
Bracket
42746-01 • 04/26/07 • Hunter® Fan Company
Steps 2-1 - 2-3:
Skirt
Section
Base Bolt
(x 16)
Base Stand
2-4. Align the holes in each skirt bracket with the
adjoining skirt section and partially install
two skirt bolts. Repeat for all skirt sections.
2-5. After all skirt sections are properly aligned,
securely tighten all skirt bolts and base bolts.

4 Small Screw Holes
Power Cord
Step 2-4:
Step Title
Channel
Base
Bolt