ENg
FREEZER ROOM DOOR REVERSE
before Door reverse
1)
- Unscrew the two plastic screws (1) on the left side with screwdriver.
)
- Take off the two screws caps (2) on the door handle bracket (3) and uninstall the door
handle bracket (3).
)
- Unscrew the freezer room door (4) on the right side and take it off. Then reverse it
and install it to the left side by using the same screws.
)
- Reverse the door handle bracket (3) and install it onto the right side and put
on the 2 screws caps (2).
)
- Install the two plastic screws (1) onto the right side with screwdriver.
5. MAINTENANCE
CLEAN ThE OUTSIDE USINg A SOFT CLOTh
Prolonged disuse
1)
Empty the refrigerator.
)
Disconnect the appliance from the power supply.
)
Defrost and clean the interior.
)
In the event of prolonged disuse, leave the door open to prevent the formation of mould,
)
odours and oxidation.
6)
Clean the appliance.
- Clean the inside of the low temperature compartment (where fitted) when defrosting.
- Periodically clean the inside of the refrigerator compartment with a sponge dampened
in warm water and/or neutral detergent. Rinse and dry with a soft cloth.
- Do not use abrasive products.Do not use abrasive products, scourers, stain-removers
e.g. acetone, trichloroethylene) or vinegar.
After Door reverse
ENG - 22