Figure 7-9. Main Circuit Board, Finger Strips, O-Ring And Battery Contact Seal Removal (Uhf1); Figure 7-10. Main Circuit Board, Finger Strips, O-Ring And Battery Contact Seal Removal (Uhf2) - Motorola CP185 Basic Service Manual

Maintenance – Non Keypad Model: Disassembling and Reassembling the Radio
7. Remove the Main Circuit Board from the Chassis.
Refer to the CMOS CAUTION paragraph under Section 7.3 before removing the main board. Be
sure to use ESD protection when handling the circuit boards.
8. Remove the seven small O-ring retainers from their slots in the Chassis. Note the alignment of
the retainers for reassembly.
9. Remove the O-ring (20) and the Battery Contact Seal (24). (Refer Figure 7-10).
10. Remove the finger strips from the Chassis. Reuse the finger strips if chassis change is required
only. Note the alignment of the finger strips for assembly.
Finger Strip
O-Ring
Battery Contact Seal

Figure 7-9. Main Circuit Board, Finger Strips, O-ring and Battery Contact Seal Removal (UHF1)

O-Ring
Battery Contact Seal

Figure 7-10. Main Circuit Board, Finger Strips, O-ring and Battery Contact Seal Removal (UHF2)

Finger Strip
7-11