Samson RSX M10a Owner's Manual page 9

Quick Start
1.
Turn the Volume controls on the rear panel fully counterclockwise.
2. If using as floor monitors set the MONITOR/FOH switch to the MONITOR positions.
3. Turn the Power switch OFF.
4. Connect the Monitor output from your mixer to the Input jack on the RSXM10a/RSXM12a rear
panel.
5. If connecting an additional speaker, connect the XLR Line Output of the first speaker to the Input
of the second RSXM speaker.
6.
Connect the supplied power cable to the AC Power Inlet on the back of the loudspeaker. Plug the
power cable into an AC outlet.
Note: Always make sure that the AC outlet is configured with the correct voltage as indicated on
the rear panel of the RSX loudspeaker.
7.
Switch the RSXM Power switch to the ON position.
8. Run an audio signal from your mixer.
9. Slowly raise the RSXM VOL control until you have reached the desired level.
10. If the sound from the speakers sounds distorted, or you see the LIMITER indicator blinking
frequently, turn down the Input Level control on the RSX loudspeaker until the indicator does not
light.
RSX Active Loudspeakers 9