Quick Start - Samson RSX M10a Owner's Manual

Quick Start

1.
Turn the Volume controls on the rear panel fully counterclockwise.
2. Set the EQ switch to the Flat positions.
3. Turn the Power switch OFF.
4. Connect either a line level signal from your mixer (or other audio source) or a microphone to the
Input 1 jack or a line level signal to the Input 2 jack on the RSX112a/RSX115a rear panel. If
using a microphone, set the Mic/Line Switch to the microphone position.
5. If connecting an additional speaker, connect the XLR Mix Output of the first speaker to the Input
of the second RSX speaker.
6. Connect the supplied power cable to the AC Power Inlet on the back of the loudspeaker. Plug the
power cable into an AC outlet.
Note: Always make sure that the AC outlet is configured with the correct voltage as indicated on
the rear panel of the RSX loudspeaker.
7. Switch the RSX Power switch to the ON position.
8. Run an audio signal from your mixer, or talk into the microphone.
9. Slowly raise the RSX input VOL control until you have reached the desired level.
10. If the sound from the speakers sounds distorted, or you see the LIMITER indicator blinking
frequently, turn down the Input Level control on the RSX loudspeaker until the indicator does not
light.
8