Manual Information - BRP Commander 800R Can-Am 2013 Shop Manual

EPA EMISSION REGULATIONS
Vehicles manufactured by BRP are certified to the
EPA standards as conforming to the requirements
of the regulations for the control of air pollution
emitted from new vehicle engines. This certifica-
tion is contingent on certain adjustments being
set to factory standards. For this reason, the
factory procedure for servicing the product must
be strictly followed and, whenever practicable,
returned to the original intent of the design.
The responsibilities listed above are general and
in no way a complete listing of the rules and regu-
lations pertaining to the EPA requirements on ex-
haust emissions. For more detailed information
on this subject, you may contact the following lo-
cations:
FOR ALL COURIER SERVICES:
U.S. Environmental Protection Agency
Office of Transportation and Air Quality
1310 L Street NW
Washington D.C. 20005
REGULAR US POSTAL MAIL:
1200 Pennsylvania Ave. NW
Mail Code 6403J
Washington D.C. 20460
INTERNET: http://www.epa.gov/otaq/
E-MAIL: otaqpublicweb@epa.gov

MANUAL INFORMATION

MANUAL PROCEDURES
Many of the procedures in this manual are inter-
related. Before undertaking any task, you should
read and thoroughly understand the entire section
or subsection in which the procedure is contained.
WARNING
Unless otherwise specified,
should be turned OFF and cold for all main-
tenance and repair procedures.
A number of procedures throughout the book re-
quire the use of special tools. Before starting any
procedure, be sure that you have on hand all re-
quired tools, or their approved equivalents.
The use of RIGHT and LEFT indications in the text
are always referenced to the driving position (sit-
ting on the vehicle).
tmr2013-002
tmr2011-002-003_a
TYPICAL
1. Left
2. Right
This manual uses technical terms which may be
different from the ones of the
When ordering parts always refer to the specific
model
NOTICE
components are built with parts dimensioned
using the metric system. Consult the appropri-
PARTS CATALOG
ate
rect parts and fasteners. Mismatched or incor-
rect fasteners could cause damage to the vehi-
cle.
MANUAL LAYOUT
This manual is divided into many major sections as
can be seen in the main table of contents at the
beginning of the manual.
Each section is divided into various subsections,
and again, each subsection has one or more divi-
sions.
Illustrations and photos show the typical construc-
tion of various assemblies and, in all cases, may
the engine
not reproduce the full detail or exact shape of the
parts used in a particular model vehicle. However,
they represent parts which have the same or a
similar function.
INTRODUCTION
PARTS CATALOGS
PARTS CATALOGS
.
Most fasteners are metric, and most
to obtain and use the cor-
.
XIII