Hoisting The Vehicle - BRP Commander 800R Can-Am 2013 Shop Manual

tmo2011-001-315_a
1. Front of vehicle
2. Hydraulic jack
3. Jack stand
4. Lip for center skid plate
5. Center skid plate
5. Lower hydraulic lift and ensure vehicle is sup-
ported safely onto both jack stands.
Rear of Vehicle
1. Place vehicle on a flat non slippery ground.
2. Activate 4WD mode.
3. Ensure vehicle shift lever is set to PARK.
4. Install a hydraulic jack under the trailer hitch.
tmo2011-001-317_a
1. Hydraulic jack
2. Trailer hitch
5. Lift rear of vehicle and install a jack stand on
each side under frame section in front of rear
wheel.
tmr2013-002
tmo2011-001-316_a
1. Rear of vehicle
2. Jack stand
3. Frame section
6. Lower hydraulic lift and ensure vehicle is sup-
ported safely onto both jack stands.

HOISTING THE VEHICLE

The vehicle may be lifted off the ground by the
cage using a hoist and a lifting strap.
NOTICE
The lifting strap must be wrapped
around the horizontal side tubes at the top of
the cage, NOT fore and aft. Lifting vehicle by
the fore and aft tubes of the cage can cause
damage.
tmr2011-002-004_a
1. Lifting strap around horizontal side tubes (top)
2. Hoist hook
INTRODUCTION
XI